Amirkabir University of Technology AUT Journal of Civil Engineering 2588-2899 10 1 2026 02 01 Moment Capacity Assessment of Hybrid GFRP-Steel Reinforced Concrete Beams 3 14 5972 10.22060/ajce.2026.24542.5936 EN Vui Van Cao Faculty of Civil Engineering, Ho Chi Minh City University of Technology (HCMUT), 268 Ly Thuong Kiet Street, Dien Hong Ward, Ho Chi Minh City, Vietnam. Vietnam National University Ho Chi Minh City (VNU-HCM), Linh Xuan Ward, Ho Chi Minh City, Vietnam 0000-0003-2575-1540 Khanh Ba Le Faculty of Civil Engineering, Ho Chi Minh City University of Technology (HCMUT), 268 Ly Thuong Kiet Street, Dien Hong Ward, Ho Chi Minh City, Vietnam Vietnam National University Ho Chi Minh City (VNU-HCM), Linh Xuan Ward, Ho Chi Minh City, Vietnam Det Van Doan Faculty of Civil Engineering, Ho Chi Minh City University of Technology (HCMUT), 268 Ly Thuong Kiet Street, Dien Hong Ward, Ho Chi Minh City, Vietnam Vietnam National University Ho Chi Minh City (VNU-HCM), Linh Xuan Ward, Ho Chi Minh City, Vietnam Journal Article 2025 08 11 Combinations of fiber-reinforced polymer (FRP) bars and steel bars to reinforce concrete structures appear to be an advanced solution, as it combines the advantages of both materials. Research effort has been devoted to steel-reinforced concrete (RC) and FRP RC structures, while it has been limited to hybrid FRP-steel RC structures. This study thus aims at assessing the moment–curvature behavior and ultimate moment of hybrid glass FRP (GFRP)-steel RC beam sections. To achieve this aim, fiber models were developed to model beam sections reinforced with different GFRP-steel combinations. These combinations are expressed by the ratio of the GFRP area to the total area of GFRP and steel, namely rf/fs, which varies from 0 to 1. The fiber models were verified by comparing with the experimental results, with satisfactory agreement. The verified models were then used for parametric investigations considering the effect of concrete strength, steel strength, FRP strength, and rf/fs on the behavior and ultimate moment capacity of hybrid GFRP-steel beam sections. When rf/fs increases from 0 to 1, the bilinear response transitions to a linear response, and the ultimate moment increases. The pivot point is a phenomenon of the moment–curvature curves when rf/fs varies from 0 to 1. Concrete with higher compressive strength, which delays the compression failure, more effectively exploits the tensile strength of GFRP bars. GFRP bars effectively replace low-strength steel bars, resulting in a higher ultimate moment. Multivariate regression analysis was performed, and the established model indicates that the considered parameters exhibit positive effects on the ultimate moment.

https://ajce.aut.ac.ir/article_5972_d8a3a3c3234392b0add43c5f9c05a246.pdf